AUFERO AL2 Machine de gravure et de coupe laser 15 000 mm / min 10W et 5W
Taxes inclues Frais d'envoi calculés à la caisse
- Le graveur laser d'entrée de gamme le plus rapide, jusqu'à 15 000 mm / min lorsque la situation stable.
- Conçu avec un centre à basse gravité de l'axe X, offrant plus de stabilité.
- 4 Protection de la sécurité: protection de la position active, détection et limitation de la durée de l'exposition, garde de sécurité du faisceau laser, système de contrôle de sécurité actuel.
- Aufero Laser 2 bénéficie d'une garantie de retour de 30 jours et d'une garantie d'un an.
A Lot Faster Than the Typical
32-Bit MCU on the 9th Generation Motherboard Stepper motor speeds can be increased from 4000mm/min to 10,000mm/min or even 15,000mm/min thanks to the ESP32 MCU's motion algorithm and a low center of gravity.
The installation takes only 10 minutes
Whether or not you have already used a laser engraving machine, this is the best high-performance machine for novices.
Secure Design
A laser filter cover blocks 98 percent of the UV radiation. A light filter cover is attached to the laser head to keep animals from grabbing the laser spot. The laser will immediately shut off to prevent any harm if the machine is tilted or shifted, if the computer fails during engraving or if the motors stop moving.
Newest Compressed Focal Spot Laser Beam Innovations
Cutting depth of up to 12mm thick wood, 10mm acrylic, carving ceramics, and stainless steel can all be done with the latest Aufero AL2 5.5W high-compression focal point laser module diode.
【10W】Wood & Acrylic Cutting
One PASS-Without Pump
Wood (12mm)
Acrylic (1Omm)
Technical Specifications
