Home / Materials Reference
Materials
LU2-4 Cutting
LU2-4 Engraving
Remark
1.6mm Plywood Plate
300mm/min,S1000
Run 1 pass
10000mm/min,S1000
Darker Colors, Better Results.
2.8mm Plywood Plate
100mm/min,S1000
10000mm/min,S1000
Darker Colors, Better Results.
4mm Plywood Plate
100mm/min,S1000
10000mm/min,S1000
Darker Colors, Better Results.
7mm Pine board
100mm/min,S1000
Run 2 passes
10000mm/min,S1000
Darker Colors, Better Results.
9mm Pine board
100mm/min,S1000
Run 3 passes
10000mm/min,S1000
Darker Colors, Better Results.
0.1mm Colored A4 Paper
(Not White)
4000mm/min,S1000
Run 2 passes
9000mm/min,S350
The white paper is non-opaque, the result is not very good.
0.3mm Colored A4 Paper
(Not White)
1000mm/min,S1000
9000mm/min,S700
The white paper is non-opaque, the result is not very good.
250g Kraft Paper
1000mm/min,S1000
9000mm/min,S500
Darker Colors, Better Results.
3mm Paperboard
(Cardboard Box)
300mm/min,S1000
9000mm/min,S400
Darker Colors, Better Results.
0.7MM Leather
600mm/min,S1000
10000mm/min,S1000
Darker Colors, Better Results.
Non-woven fabrics
(0.5mm, Dark Color)
Cutting
2300mm/min,S1000
/
Cannot cut the white one, it's transparent in fact.
Some Plastic Sheet
(Dark Color)
/
3000mm/min,S600
Some plastic sheets may be melt.
5mm Acrylic
100mm/min,S1000
Run 3 passes
10000mm/min,S1000
Need coat the dark color paper onto the transparent Acrylic plate.
Tin Wire
Melting
/
Cannot engrave.
Cobblestone
/
100mm/min,S1000
Need coated with acrylic dye heat transfer film.
Ceramic
/
100mm/min,S1000
Need coated with acrylic dye heat transfer film.
Powder Coated Metal
Paint Sprayed Metal
/
10000mm/min,S1000
Engraved in the layer of powder coating.
Plated Metal
/
100mm/min,S1000
It's the surface color turned to be other color.
The Glossy finishing surface should be painted black by Marker Pen.
Anodized Aluminium
/
10000mm/min,S1000
Stainless Steel
/
100mm/min,S1000
Copper
/
Engraving
mm/min,S
The results can be different even in the same material if they have different finishing or different colors, so you need to adjust the speed and power rate based on different objects. Also, please adjust the focal length to be the best, make the focal spot to be the smallest. The following materials can be difficult to engrave or cut directly: Glossy metal plate, Transparent materials, Reflecting materials, Some materials in white color or impervious to light, etc. For these materials you may need to use the marker pen to darken it to enable engraving.