No Products in the Cart
The laser module has been used for a long time or has not been used for a long time. The lens becomes dirty and it is difficult to pass through the laser, which causes the lens to overheat and crack.
The air assist is installed, but the air pump is not connected, so the process of lens contamination is accelerated, and finally the laser cannot pass through the lens, resulting in lens breakage and damage.
Can be Adjusted in Multiple Directions to Meet Daily Engraving Needs.
Two steps for adjusting the screw.
Two minutes down for everything.
No installation required, easy to use, direct power supply and control through the laser engraver.